Diagnosis Procedure
- CHECK DETECTED DTC
Refer to DTC Description .
Was DTC B1F10 detected?
YES
GO TO 2 .
NO
If DTC B1F11 was detected, GO TO 3
NO
If DTC B1F12 was detected, GO TO 4
NO
If DTC B1F13 was detected, GO TO 5
- CHECK FRONT RIGHT MICROPHONE (ACTIVE NOISE CONTROL) CIRCUITS FOR OPEN
- Turn ignition switch OFF.
- Disconnect BOSE speaker amp. connector B149 and front right microphone (Active Noise Control) connector.
- Check continuity between BOSE speaker amp. connector B149 and front right microphone (Active Nose Control) connector R19.
BOSE speaker amp.
Front right microphone (Active Noise Control)
Continuity
Connector
Terminal
Connector
Terminal
B149
60
R19
1
Yes
40
2
Is the inspection result normal?
YES
GO TO 6 .
NO
Repair or replace harness or connectors.
- CHECK FRONT RIGHT MICROPHONE (ACTIVE NOISE CONTROL) CIRCUITS FOR SHORT
- Turn ignition switch OFF.
- Disconnect BOSE speaker amp. connector B149 and front right microphone (Active Nose Control) connector.
- Check continuity between the terminals of BOSE speaker amp. connector B149.
Bose speaker amp. connector B149
Continuity
Terminal
Terminal
60
40
No
Is the inspection result normal?
YES
GO TO 6 .
NO
Repair or replace harness or connectors.
- CHECK FRONT RIGHT MICROPHONE (ACTIVE NOISE CONTROL) CIRCUITS FOR SHORT TO VOLTAGE
- Turn ignition switch OFF.
- Disconnect BOSE speaker amp. connector B149 and front right microphone (Active Nose Control) connector.
- Turn ignition switch ON.
- Check voltage between BOSE speaker amp. connector B149 and ground.
BOSE speaker amp.
Ground
Voltage
(Approx.)
Connector
Terminal
B149
60
(-)
0 V
40
Is the inspection result normal?
YES
GO TO 6 .
NO
Repair or replace harness or connectors.
- CHECK FRONT RIGHT MICROPHONE (ACTIVE NOISE CONTROL) CIRCUITS FOR SHORT TO GROUND
- Turn ignition switch OFF.
- Disconnect BOSE speaker amp. connector B149 and front right microphone (Active Noise Control) connector.
- Check continuity between BOSE speaker amp. connector B149 and ground.
BOSE speaker amp.
Ground
Continuity
Connector
Terminal
B149
60
-
No
40
Is the inspection result normal?
YES
GO TO 6 .
NO
Repair or replace harness or connectors.
- CHECK FRONT RIGHT MICROPHONE (ACTIVE NOISE CONTROL) SIGNAL
- Turn ignition switch OFF.
- Connect BOSE speaker amp. connector B149 and front right microphone (Active Nose Control) connector.
- Turn ignition switch ON.
- Check signal between the terminals of BOSE speaker amp. connector B149.
Bose speaker amp. connector B149
Condition
Reference value
(+)
(-)
Terminal
Terminal
60
40
Input interior sound
Is the inspection result normal?
YES
Replace BOSE speaker amp. Refer to Removal and Installation .
NO
Replace front right microphone (Active Noise Control). Refer to Removal and Installation - Front .