Backup Collision Intervention System Operation Description
WARNING: This page is about a different car, the 2020 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
- ADAS control unit enables Backup Collision Intervention system.
- The BCI system is automatically turned ON every time the engine is started. Then BCI ON indicator comes on.
- Combination meter turns Backup Collision Intervention ON indicator lamp ON/OFF according to the signals from ADAS control unit via CAN communication.
- Side radar detects a vehicle approaching, and transmits the vehicle detection signal to ADAS control unit via ITS communication.
- Side radar receives vehicle speed signal from ADAS control unit and changes its detecting function.
- ADAS control unit starts the control as follows, based on a vehicle detection signal.
Operation Condition of Backup Collision Intervention System
ADAS control unit performs the control when the following conditions are satisfied.
- Backup Collision Intervention ON indicator: ON
- When the vehicle is moving in reverse at 5 MPH (8 km/h) or less.
NOTE:
- When the Backup Collision Intervention system setting is ON in the meter display.
- Backup Collision Intervention braking will not function properly under the following conditions:
- When driving with a tire that is not within normal tire conditions (pressure, wear, chain, spare, etc...)
- When the vehicle is equipped with non-original brake parts or suspension parts.
- Do not use the BCI system when towing a trailer.
- Excessive noise such as the audio system will interfere with the chime sound, and it may not be heard.