Diagnosis Procedure

WARNING: This page is about a different car, the 2020 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

The system setting cannot be turned ON/OFF in the combination meter information display using the steering switch.

CHECK BSW SYSTEM SETTING
1. Start the engine.
2. Check that the BSW system setting can be turned ON/OFF in the combination meter information display using the steering switch.
Is the inspection result normal?

YES

Inspection End.

NO

GO TO 2.
CHECK STEERING SWITCH CIRCUIT
Check the steering switch. Refer to Diagnosis Procedure .

Is the inspection result normal?

YES

GO TO 3.

NO

Repair or replace harness or connector.
CHECK STEERING SWITCH RESISTANCE
Check the steering switch resistance. Refer to Component Inspection .

Is the inspection result normal?

YES

Replace combination meter. Refer to Removal and Installation .

NO

Replace steering switch. Refer to Removal and Installation .