Diagnosis Procedure

WARNING: This page is about a different car, the 2020 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

When ICC system is active, the ICC system does not perform any control even through there is a vehicle ahead.

CHECK ICC SYSTEM DISPLAY ON INFORMATION DISPLAY
1. Start the self-diagnosis mode of combination meter. Refer to Description .
2. Check that the information display turns ON normally.
Is the inspection result normal?

YES

GO TO 2.

NO

Replace the combination meter.
VISUAL CHECK (1)
Check the contamination and foreign matter on the distance sensor (ICC sensor) area of the front bumper.

Does foreign matter interfere?

YES

GO TO 4.

NO

GO TO 3.
VISUAL CHECK (2)
1. Remove the front bumper. Refer to Removal and Installation
2. Check distance sensor (ICC sensor) for contamination and foreign matter.
Does foreign matter interfere?

YES

GO TO 4.

NO

GO TO 5.
WIPE OUT DIRT AND FOREIGN MATTER
Wipe out the contamination and foreign matter in the area around the distance sensor (ICC sensor).

GO TO 9.
VISUAL CHECK (3)
Check distance sensor (ICC sensor) for cracks and/or scratches.

Are there cracks?

YES

GO TO 7.

NO

GO TO 6.
RADAR ALIGNMENT ADJUSTMENT
1. Install the front bumper. Refer to Removal and Installation
2. Adjust the radar alignment.
3. Perform ICC system action test. Refer to Description .
4. Check that the vehicle ahead detection performance improves.
Does it improve?

YES

INSPECTION END

NO

GO TO 8.
REPLACE DISTANCE SENSOR (ICC SENSOR)
1. Replace the distance sensor (ICC sensor). Refer to Removal and Installation .
2. Install the front bumper. Refer to Removal and Installation .
3. Adjust the radar alignment.
4. Perform ICC system action test. Refer to Description .
5. Check that the vehicle ahead detection performance improves.
Does it improve?

YES

INSPECTION END

NO

GO TO 8.
REPLACE ADAS CONTROL UNIT
Replace ADAS control unit. Refer to Removal and Installation .

GO TO 9.
CHECK ICC SYSTEM
1. Erase the self-diagnosis results, and then perform "All DTC Reading" again after performing the action test. (Refer to Description for action test.)
2. Check that the ICC system is normal.
INSPECTION END