LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 633 (Cruise Control System) >> Ecu Diagnosis Information >> Distance Sensor (ICC Sensor) >> Values on the Diagnosis Tool

Values on the Diagnosis Tool

WARNING: This page is about a different car, the 2020 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

Monitor item

Condition

Value/Status

VHCL SPEED SE

While driving

Value of vehicle speed signal (wheel speed)

YAW RATE

While driving

Vehicle stopped

0.0

Vehicle turning right

Positive value

Vehicle turning left

Negative value

PWR SUP MONI

Ignition switch ON

Power supply voltage value of distance sensor (ICC sensor)

DISTANCE

Drive the vehicle and activate the vehicle-to-vehicle distance control mode

When a vehicle ahead is detected

Displays the distance from the preceding vehicle

When a vehicle ahead is not detected

0.0

RELATIVE SPD

Drive the vehicle and activate the vehicle-to-vehicle distance control mode

When a vehicle ahead is detected

Displays the relative speed

When a vehicle ahead is not detected

0.0

RADAR OFFSET

NOTE: The item is indicated, but not used

--

RADAR HEIGHT

NOTE: The item is indicated, but not used

--

STEERING ANGLE

Ignition switch ON

When setting the steering wheel in straight-ahead position

0.0

When turning the steering wheel 90 deg. rightward

+90

When turning the steering wheel 90 deg. leftward

-90

STRG ANGLE SPEED

Ignition switch ON

At the time of turning the steering wheel

Steering wheel turning speed is displayed

L/R ADJUST

Ignition switch ON

At the completion of radar alignment adjustment

Horizontal correction value is displayed

U/D ADJUST

Ignition switch ON

At the completion of radar alignment adjustment

Vertical correction value is displayed