DTC Confirmation Procedure
WARNING: This page is about a different car, the 2020 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
- PERFORM DTC CONFIRMATION PROCEDURE
- Start the engine.
- Turn the DCA system ON.
- Perform "All DTC Reading" with CONSULT.
- Check if the "U1010" is detected as the current malfunction in "Self Diagnostic Result" of "ICC/ADAS".
Is "U1010" detected as the current malfunction?
YES
Refer to Diagnosis Procedure .
NO
To check malfunction symptom before repair: Refer to Intermittent Incident .
NO
Confirmation after repair: INSPECTION END