Driver Assistance System (DTC/Circuit Diagnosis)
WARNING: This page is about a different car, the 2020 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK BLIND SPOT WARNING/BLIND SPOT INTERVENTION INDICATOR CIRCUIT FOR SHORT
- Turn ignition switch OFF.
- Disconnect side radar RH harness connector and Blind Spot Warning/Blind Spot Intervention indicator harness connector.
- Check continuity between side radar RH harness connector and ground.
Side radar RH
Ground
Continuity
Connector
Terminal
B109
4
Not existed
Is the inspection result normal?
YES
GO TO 2.
NO
Repair the harnesses or connectors.
- REPLACE THE SIDE RADAR
- Replace the side radar.
- Perform "All DTC Reading" with CONSULT.
- Check if the "C1B51-16" is detected in "Self Diagnostic Result" of "Side radar (Rear right)".
Is the DTC "C1B51-16" detected?
YES
Replace the side radar. Refer to Removal and Installation .
NO
INSPECTION END