Work Procedure

WARNING: This page is about a different car, the 2018 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

WRITING MODE SELECTION
CONSULT Configuration

Select "Re/programming, Configuration" of MULTI AV.

When writing saved data

GO TO 2 .

When writing manually

GO TO 3 .
PERFORM "AFTER REPLACE ECU" OF "READ / WRITE CONFIGURATION"
CONSULT Configuration

Perform "After Replace ECU" of "Read / Write Configuration".

WORK END
PERFORM "MANUAL CONFIGURATION"
CONSULT Configuration
1. Select "Manual Configuration".
2. Identify the correct model and configuration list. Refer to Configuration list .
3. Confirm and/or change setting value for each item.
  CAUTION: Thoroughly read and understand the vehicle specification. ECU control may not operate normally if the setting is not correct.
  
  NOTE: If items are not displayed, touch "Next". Refer to Configuration list for written items and setting value.
4. Touch "Next".
5. Touch "OK".
  CAUTION: Make sure to select "OK" even if the indicated configuration of brand new AV control unit is the same as the desired configuration. If "OK" is not selected, configuration will not be complete.
6. Check that the configuration has been successfully written and touch "End".
GO TO 4 .
OPERATION CHECK
Confirm that the AV control unit operates normally.

Work End.