LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 628 (Door & Lock (DTC/Circuit Diagnosis)) >> DTC/Circuit Diagnosis >> Outside Key Antenna (Passenger Side) >> Diagnosis Procedure

Diagnosis Procedure

WARNING: This page is about a different car, the 2020 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The Signal Tech II Tool [- (J-50190)] can be used to perform the following functions. Refer to the Signal Tech II User Guide for additional information.
  • Check Intelligent Key relative signal strength.
  • Confirm vehicle Intelligent Key antenna signal strength.
  1. CHECK OUTSIDE KEY ANTENNA INPUT SIGNAL 1 
    1. Turn ignition switch OFF.
    2. Check signal between BCM harness connector and ground using oscilloscope.

      (+)

      (-)

      Condition

      Signal

      (Reference value)

      BCM

      Connector

      Terminal

      M80

      114, 115

      Ground

      When the passenger door request switch is operated with ignition switch OFF

      When Intelligent Key is in the antenna detection area (The distance between Intelligent Key and antenna: 80 cm or less)

      GNSJMKIA0062GB-062Courtesy of NISSAN NORTH AMERICA, INC.

      When Intelligent Key is not in the antenna detection area (The distance between Intelligent Key and antenna: Approx. 2 m)

      GNSJMKIA0063GB-063Courtesy of NISSAN NORTH AMERICA, INC.

    Is the inspection result normal?

    YES

    Replace BCM. Refer to Removal and Installation .

    NO

    GO TO 2.

  2. CHECK OUTSIDE KEY ANTENNA CIRCUIT 
    1. Disconnect BCM connector and outside key antenna (passenger side) connector.
    2. Check continuity between BCM harness connector and outside key antenna (passenger side) harness connector.

      BCM

      Outside key antenna (passenger side)

      Continuity

      Connector

      Terminal

      Connector

      Terminal

      M80

      114

      D118

      1

      Yes

      115

      2

    3. Check continuity between BCM harness connector and ground.

      BCM

      Ground

      Continuity

      Connector

      Terminal

      M80

      114

      No

      115

    Is the inspection result normal?

    YES

    GO TO 3.

    NO

    Repair or replace harness.

  3. CHECK OUTSIDE KEY ANTENNA INPUT SIGNAL 2 
    1. Replace outside key antenna (passenger side). (New antenna or other antenna)
    2. Connect BCM connector and outside key antenna (passenger side) connector.
    3. Check signal between BCM harness connector and ground using oscilloscope.

      (+)

      (-)

      Condition

      Signal

      (Reference value)

      BCM

      Connector

      Terminal

      M80

      114, 115

      Ground

      When the passenger door request switch is operated with ignition switch OFF

      When Intelligent Key is in the antenna detection area (The distance between Intelligent Key and antenna: 80 cm or less)

      GNSJMKIA0062GB-062Courtesy of NISSAN NORTH AMERICA, INC.

      When Intelligent Key is not in the antenna detection area (The distance between Intelligent Key and antenna: Approx. 2 m)

      GNSJMKIA0063GB-063Courtesy of NISSAN NORTH AMERICA, INC.

    Is the inspection result normal?

    YES

    Replace outside key antenna (passenger side). Refer to Removal and Installation .

    NO

    Replace BCM. Refer to Removal and Installation .