LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 628 (Door & Lock (DTC/Circuit Diagnosis)) >> DTC/Circuit Diagnosis >> DTC B2623: Inside Antenna >> Diagnosis Procedure

Diagnosis Procedure

WARNING: This page is about a different car, the 2020 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The Signal Tech II Tool [- (J-50190)] can be used to perform the following functions. Refer to the Signal Tech II User Guide for additional information.
  • Check Intelligent Key relative signal strength.
  • Confirm vehicle Intelligent Key antenna signal strength.
  1. CHECK INSIDE KEY ANTENNA INPUT SIGNAL 1 
    1. Turn ignition switch OFF.
    2. Check signal between BCM harness connector and ground using oscilloscope.

      (+)

      (-)

      Condition

      Signal

      (Reference value)

      BCM

      Connector

      Terminal

      M20

      100, 99

      Ground

      When Intelligent Key is in the antenna detection area

      GNSJMKIA0062GB-062Courtesy of NISSAN NORTH AMERICA, INC.

      When Intelligent Key is not in the antenna detection area

      GNSJMKIA0063GB-063Courtesy of NISSAN NORTH AMERICA, INC.

    Is the inspection result normal?

    YES

    Replace BCM. Refer to Removal and Installation .

    NO

    GO TO 2.

  2. CHECK INSIDE KEY ANTENNA CIRCUIT 
    1. Disconnect BCM connector and inside key antenna (luggage room) connector.
    2. Check continuity between BCM harness connector and inside key antenna (luggage room) harness connector.

      BCM

      Inside key antenna (luggage room)

      Continuity

      Connector

      Terminal

      Connector

      Terminal

      M20

      100

      B76

      1

      Yes

      99

      2

    3. Check continuity between BCM harness connector and ground.

      BCM

      Ground

      Continuity

      Connector

      Terminal

      M20

      100

      No

      99

    Is the inspection result normal?

    YES

    GO TO 3.

    NO

    Repair or replace harness.

  3. CHECK INSIDE KEY ANTENNA INPUT SIGNAL 2 
    1. Replace inside key antenna (luggage room). (New antenna or other antenna)
    2. Connect BCM connector and inside key antenna (luggage room) connector.
    3. Check signal between BCM harness connector and ground using oscilloscope.

      (+)

      (-)

      Condition

      Signal

      (Reference value)

      BCM

      Connector

      Terminal

      M20

      100, 99

      Ground

      When Intelligent Key is in the antenna detection area

      GNSJMKIA0062GB-062Courtesy of NISSAN NORTH AMERICA, INC.

      When Intelligent Key is not in the antenna detection area

      GNSJMKIA0063GB-063Courtesy of NISSAN NORTH AMERICA, INC.

    Is the inspection result normal?

    YES

    Replace inside key antenna (luggage room). Refer to Removal and Installation .

    NO

    Replace BCM. Refer to Removal and Installation .