Diagnosis Procedure

Check for entry of foreign materials in back door lock assembly.

Is the inspection result normal?

YES

GO TO 2.

NO

Remove foreign materials.

Manually check open and close operation of back door.

Is the inspection result normal?

YES

GO TO 3.

NO

Repair or replace the malfunctioning parts.

1. Select AUTOMATIC BACK DOOR CONTROL MODULE using CONSULT.
2. Select HALF LATCH SW, OPEN SW and CLOSE SW in DATA MONITOR mode.
3. Check that the function operates normally according to the following conditions.

Is the inspection result normal?

YES

GO TO 8.

NO

GO TO 4.

1. Turn ignition switch OFF.
2. Disconnect back door lock assembly connector.
3. Check voltage between back door lock assembly harness connector and ground.

   (+)		(-)	Voltage (Approx.)
   Back door lock assembly
   Connector	Terminal
   D557	4	Ground	Battery voltage
   	5
   	6

Is the inspection result normal?

YES

GO TO 6.

NO

GO TO 5.

1. Disconnect automatic back door control module connector.
2. Check continuity between automatic back door control module harness connector and back door lock assembly harness connector.

   Automatic back door control module		Back door lock assembly		Continuity
   Connector	Terminal	Connector	Terminal
   B55	3	D557	6	Yes
   	5		5
   	11		4

3. Check continuity between automatic back door control module harness connector and ground.

   Automatic back door control module		Ground	Continuity
   Connector	Terminal
   B55	3		No
   	5
   	11

Is the inspection result normal?

YES

Replace automatic back door control module. Refer to Removal and Installation .

NO

Repair or replace harness.

Check continuity between back door lock assembly harness connector and ground.

Is the inspection result normal?

YES

GO TO 7.

NO

Repair or replace back door lock assembly ground circuit.

Refer to Component Inspection .

Is the inspection result normal?

YES

GO TO 8.

NO

Replace back door lock assembly. Refer to Removal and Installation .

Refer to Intermittent Incident .

Inspection End.