Additional Service When Replacing Control Unit: Description
WARNING: This page is about a different car, the 2020 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
Each function is reset to the following condition when the driver seat control unit is replaced.
|
Function |
Condition |
Procedure |
|
Memory (Seat, steering, mirror) |
Erased |
Perform storing |
|
Entry/exit assist |
ON |
Perform initialization |
|
Set slide amount *1 |
||
|
Intelligent Key interlock |
Erased |
Perform initialization |
|
Perform storing |
*1 : Default value is 40 mm.
NOTE:
Notice that disconnecting the battery when detected DTC are present will erase the DTC memory.