DTC Confirmation Procedure

If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON.
3. Turn ignition switch OFF and wait at least 10 seconds.

TESTING CONDITION:

Always perform test at a temperature of 5 deg.C (41 deg.F) or more.

Do you have CONSULT

YES

GO TO 2.

NO

GO TO 3.

With CONSULT

1. Start engine and warm it up to normal operating temperature.
2. Turn ignition switch OFF and wait at least 10 seconds.
3. Turn ignition switch ON.
4. Turn ignition switch OFF and wait at least 10 seconds.
5. Turn ignition switch ON.
6. On CONSULT screen, select "ENGINE">>"DTC Work Support">>"EVAPORATIVE SYSTEM">>"PURG VOL CN/V P1444".
7. Touch "START".
8. Start engine and let it idle until "TESTING" on CONSULT changes to "COMPLETED". (It will take approximately 10 seconds.)

   If "TESTING" is not displayed after 5 minutes, retry from step 2.

9. Touch "SELF-DIAG RESULTS".

Is "OK" displayed on CONSULT screen?

YES

To check malfunction symptom before repair: Refer to Intermittent Incident .

YES

Confirmation after repair: INSPECTION END

NO

Proceed to Diagnosis Procedure .

With GST

1. Start engine and warm it up to normal operating temperature.
2. Turn ignition switch OFF and wait at least 10 seconds.
3. Turn ignition switch ON.
4. Turn ignition switch OFF and wait at least 10 seconds.
5. Start engine and let it idle for at least 20 seconds.
6. Check 1st trip DTC.

Is DTC P0443 displayed?

YES

Proceed to Diagnosis Procedure .

NO

To check malfunction symptom before repair: Refer to Intermittent Incident .

NO

Confirmation after repair: INSPECTION END