Confirmation Procedure

WARNING: This page is about a different car, the 2020 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Never refuel before and during the following procedure.

CHECK DTC PRIORITY
If DTC P01F0 is displayed with DTC P0116, P0117, P0118, or P0128, first perform the trouble diagnosis for DTC P0116, P0117, P0118, or P0128.

Is other DTC detected?

YES

Perform diagnosis of applicable. Refer to DTC Index .

NO

GO TO 2.
PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.
1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON.
3. Turn ignition switch OFF and wait at least 10 seconds.
GO TO 3.
PERFORM DTC CONFIRMATION PROCEDURE
With CONSULT
1. Start engine and warm it up to the normal operating temperature.
2. Maintain the hold vehicle speed at more than 60 km/h (37 MPH) for at least 40 consecutive seconds.
  CAUTION: Always drive vehicle in safe manner according to traffic conditions and obey all traffic laws.
  
  NOTE: Keeping the accelerator pedal as steady as possible at approximately more than 1/8.
Is DTC detected?

YES

Refer to DTC Diagnosis Procedure .

NO

To check malfunction symptom before repair: Refer to Intermittent Incident .

NO

Confirmation after repair: INSPECTION END