Component Inspection

WARNING: This page is about a different car, the 2020 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

CHECK ICC STEERING SWITCH

Turn ignition switch OFF.
Disconnect combination switch (spiral cable) harness connector M149.

Check resistance between combination switch harness connector terminals under the following conditions.

Combination switch			Condition	Resistance (Approx.)
Connector	Terminals
M149	13	16	MAIN switch: Pressed	0 Ohm
			DYNAMIC DRIVE ASSISTANCE switch: Pressed	267 Ohm
			CANCEL switch: Pressed	615 Ohm
			DISTANCE switch: Pressed	1, 090 Ohm
			COAST/SET switch: Pressed	1, 805 Ohm
			ACCEL/RES switch: Pressed	2, 985 Ohm
			All ICC steering switches: Released	5, 415 Ohm

Is the inspection result normal?

YES

INSPECTION END

Replace ICC steering switch. Refer to Removal and Installation .