Component Inspection
WARNING: This page is about a different car, the 2020 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK EVAP CANISTER PURGE VOLUME CONTROL SOLENOID VALVE
With CONSULT
- Turn ignition switch OFF.
- Reconnect all harness connectors disconnected.
- Disconnect EVAP purge hoses connected to EVAP canister purge volume control solenoid valve.
- Start the engine.
- On CONSULT screen, select "ENGINE">>"Active Test">>"PURG VOL CONT/V".
- Touch "Qd" and "Qu" on CONSULT screen to adjust "PURG VOL C/V" opening and check air passage continuity of EVAP canister purge volume control solenoid valve under the following conditions.
Condition
(PURG VOL C/V value)
Air passage continuity
between
and
100%
Existed
0%
Not existed
Without CONSULT
- Turn ignition switch OFF.
- Disconnect EVAP canister purge volume control solenoid valve harness connector.
- Disconnect EVAP purge hoses connected to EVAP canister purge volume control solenoid valve.
- Check air passage continuity of EVAP canister purge volume control solenoid valve under the following conditions.
Condition
Air passage continuity
between
12 V direct current supply between terminals 1 and 2
Existed
No supply
Not existed
Is the inspection result normal?
YES
INSPECTION END
NO
Replace EVAP canister purge volume control solenoid valve. Refer to Component Parts Location .