Removal and Installation of Rear Oil Seal: Removal
WARNING: This page is about a different car, the 2020 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the upper oil pan. Refer to Removal and Installation (Upper Oil Pan) .
- Remove drive plate. Refer to Dowel Pin Alignment .
- Remove rear oil seal retainer using Tool.
Tool Number
: KV10111100 (J-37228)
CAUTION:- Do not damage mating surface.
- If rear oil retainer is removed, replace it with a new one.
NOTE: Rear oil seal and retainer form a single part and are replaced as an assembly.