LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 615 (Engine Mechanical) >> Removal And Installation >> Oil Seal >> Removal and Installation of Front Oil Seal >> Removal

Removal and Installation of Front Oil Seal: Removal

WARNING: This page is about a different car, the 2020 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove drive belt. Refer to Removal and Installation .
  2. Lock the drive plate using Tool.

    Tool number

    : --(J-50288)
    CAUTION: Do not damage the ring gear teeth or the signal plate teeth behind the ring gear when setting the Tool.
  3. Remove the crankshaft pulley as follows:
    1. Loosen crankshaft pulley and locate bolt seating surface at 10 mm (0.39 in) from its original position.
    2. Position a pulley puller at recess hole of crankshaft pulley to remove crankshaft pulley.
      G00501270Courtesy of NISSAN NORTH AMERICA, INC.
      CAUTION: Do not use a puller claw on the outer diameter of the crankshaft pulley.
  4. Remove front oil seal from front cover using a suitable tool.
    G04195887Courtesy of NISSAN NORTH AMERICA, INC.
    CAUTION: Do not damage front cover or crankshaft.
scientia non olet · About LEMON Manuals