Removal and Installation: Installation

WARNING: This page is about a different car, the 2020 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Do not damage or spill engine oil on the engine mount insulator (front).
Check engine mount insulator (front) is seated properly before tightening.

Install the engine mount insulator (front).

Courtesy of NISSAN NORTH AMERICA, INC.

Install the engine mount insulator (front) bolts and tighten to specification in the order shown, below.

Fig 1: Engine Mount Insulator (Front) Bolt Tightening Sequence

Courtesy of NISSAN NORTH AMERICA, INC.

: Front

Engine mount insulator (front) bolts

: 55 N.m (5.6 kg-m, 41 ft-lb)

Install the engine mount bracket (front) to the engine block.

Tighten the engine mount bracket (front) bolts to specification in the order shown, below.

Fig 2: Engine Mount Bracket (Front) Bolt Tightening Sequence

Courtesy of NISSAN NORTH AMERICA, INC.

: Engine front

Engine mount bracket (front) bolts

: 40 N.m (4.1 kg-m, 30 ft-lb)

Install the engine mount insulator (front) nut (A) and tighten to specification.

Courtesy of NISSAN NORTH AMERICA, INC.

Engine mount insulator (front) nut

: 103 N.m (11 kg-m, 76 ft-lb)

Installation of the remaining components is in the reverse order of removal.