LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 615 (Engine Mechanical) >> Removal And Installation >> Air Cleaner And Air Duct >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2020 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove front air duct.
  2. Disconnect the tube clamp at the electric throttle control actuator and at the air duct hose and resonator assembly.
  3. Disconnect the blow-by hose from air duct hose and resonator assembly.
  4. Remove air duct hose and resonator assembly.
  5. Disconnect the harness connector from mass air flow sensor and release harness retainer from air cleaner case (upper).
  6. Disconnect the transaxle breather hose from air cleaner case (lower).
  7. Remove bolts and pull air cleaner case (lower) upward to remove from the grommets.
  8. Remove air cleaner assembly.
  9. Remove mass air flow sensor from air cleaner case (upper) (if necessary).
    CAUTION: Handle mass air flow sensor with care.
    • Do not shock it.
    • Do not disassemble it.
    • Do not touch its sensor.
  10. Release the clips and remove the air cleaner case (upper) from the air cleaner case (lower) (if necessary).
  11. Remove air cleaner filter from air cleaner case (lower) (if necessary).
scientia non olet · About LEMON Manuals