LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 615 (Engine Mechanical) >> Periodic Maintenance >> Drive Belt >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2020 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front wheel and tire (RH) using power tool. Refer to Adjustment .
  2. Remove the front fender protector side cover (RH). Refer to Exploded View .
  3. While securely holding the hexagonal part in pulley center of drive belt auto-tensioner, move in the direction of arrow (loosening direction of drive belt auto-tensioner) using suitable tool.
    G08688525Courtesy of NISSAN NORTH AMERICA, INC.
    WARNING: Avoid placing hand in a location where pinching may occur if the holding tool accidentally comes off.
    CAUTION: Do not loosen the drive belt auto-tensioner pulley bolt. (Do not turn it counterclockwise. If turned counterclockwise, the complete drive belt auto-tensioner must be replaced as a unit, including pulley.)
  4. Insert a rod approximately 6 mm (0.24 in) in diameter through the rear of drive belt auto-tensioner into retaining boss to lock drive belt auto-tensioner pulley.
    NOTE: Leave drive belt auto-tensioner pulley arm locked until drive belt is installed.
  5. Remove drive belt from crankshaft pulley and then remove it from the other pulleys.
scientia non olet · About LEMON Manuals