LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 615 (Engine Mechanical) >> Periodic Maintenance >> Drive Belt >> Removal and Installation >> Installation

Removal and Installation: Installation

WARNING: This page is about a different car, the 2020 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the drive belt onto all of the pulleys.
    CAUTION: Confirm belt is completely set on the pulleys.
  2. Release drive belt auto-tensioner, and apply tension to drive belt.
    WARNING: Avoid placing hand in a location where pinching may occur if the holding tool accidentally comes off.
    CAUTION: Do not loosen the drive belt auto-tensioner pulley bolt. (Don't turn it counterclockwise. If turned counterclockwise, the complete drive belt auto-tensioner must be replaced as a unit, including pulley.)
  3. Turn crankshaft pulley clockwise several times to equalize tension between each pulley.
  4. Confirm drive belt auto-tensioner indicator is within the possible use range. Refer to Checking Drive Belt .
  5. Install the front fender protector side cover (RH). Refer to Exploded View .
  6. Install the front wheel and tire (RH) using power tool. Refer to Adjustment .
scientia non olet · About LEMON Manuals