Component Inspection (Rear Blower Motor Resistor)

WARNING: This page is about a different car, the 2020 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

CHECK FAN CONTROL AMP.

Turn ignition switch OFF.
Remove rear blower motor resistor. Refer to Removal and Installation - Rear Blower Motor Resistor 1 or Removal and Installation - Rear Blower Motor Resistor 2 .

Check continuity between the rear blower motor resistor terminals using analog circuit tester.

Terminal		Continuity
(+)	(-)	Continuity
3	2	Yes
2	3	No

Is the inspection result normal?

YES

Inspection End.

Replace rear blower motor resistor. Refer to Removal and Installation - Rear Blower Motor Resistor 1 or Removal and Installation - Rear Blower Motor Resistor 2 .