Diagnosis Procedure
WARNING: This page is about a different car, the 2020 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK FUSE
Check 10A fuse [No. 30, located in the fuse block (J/B)].
NOTE: Refer to appropriate wiring information .Is the inspection result normal?
YES
GO TO 2.
NO
Replace the blown fuse after repairing the affected circuit.
- CHECK REAR AIR CONTROL POWER SUPPLY
- Turn ignition switch OFF.
- Disconnect rear air control connector.
- Turn ignition switch ON.
- Check voltage between rear air control harness connector and ground.
+
-
Voltage
(Approx.)
Rear air control
Connector
Terminal
M258
12
Ground
Battery voltage
Is the inspection result normal?
YES
GO TO 3.
NO
Repair harness or connector between rear air control and fuse block (J/B).
- CHECK REAR AIR CONTROL GROUND CIRCUIT
- Turn ignition switch OFF.
- Check continuity between rear air control harness connector and ground.
Rear air control
--
Continuity
Connector
Terminal
M258
1
Ground
Yes
Is the inspection result normal?
YES
Replace rear air control. Refer to Removal and Installation .
NO
Repair harness or connector.