Values on the Diagnosis Tool

WARNING: This page is about a different car, the 2020 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The following table includes information (items) inapplicable to this vehicle. For information (items) applicable to this vehicle, refer to CONSULT display items.

Monitor Item	Condition		Value/Status
RAD FAN REQ	Engine idle speed	Changes depending on engine coolant temperature, air conditioner operation status, vehicle speed, etc.	0 - 100 %
AC COMP REQ	Engine running	A/C switch OFF	Off
		A/C switch ON (Compressor is operating)	On
TAIL&CLR REQ	Lighting switch OFF		Off
	Lighting switch 1ST, 2ND, HI or AUTO (Light is illuminated)		On
HL LO REQ	Lighting switch OFF		Off
	Lighting switch 2ND HI or AUTO (Light is illuminated)		On
HL HI REQ	Lighting switch OFF		Off
	Lighting switch HI		On
FR FOG REQ	Lighting switch 2ND or AUTO (Light is illuminated)	Front fog lamp switch OFF	Off
		Front fog lamp switch ON Daytime running light activated	On
FR WIP REQ	Push-button ignition switch ON	Front wiper switch OFF	STOP
		Front wiper switch INT	1LOW
		Front wiper switch LO	Low
		Front wiper switch HI	Hi
WIP AUTO STOP	Push-button ignition switch ON	Front wiper stop position	STOP P
		Any position other than front wiper stop position	ACT P
WIP PROT	Push-button ignition switch ON	Front wiper operates normally	Off
		Front wiper stops at fail-safe operation	BLOCK
IGN RLY1 -REQ	Push-button ignition switch OFF or ACC		Off
	Push-button ignition switch ON		On
IGN RLY	Push-button ignition switch OFF or ACC		Off
	Push-button ignition switch ON		On
PUSH SW	Release the push-button ignition switch		Off
	Press the push-button ignition switch		On
INTER/NP SW	Push-button ignition switch ON	CVT selector lever in any position other than P or N	Off
		CVT selector lever in P or N position	On
ST RLY CONT	Push-button ignition switch ON		Off
	At engine cranking		On
IHBT RLY -REQ	Push-button ignition switch ON		Off
	At engine cranking		On
ST/INHI RLY	Push-button ignition switch ON		Off
	At engine cranking		ST ->INHI
	The status of starter relay or starter control relay cannot be recognized by the battery voltage malfunction, etc. when the starter relay is ON and the starter control relay is OFF		UNKWN
DETENT SW	Push-button ignition switch ON	Press the selector button with CVT selector lever in P position CVT selector lever in any position other than P	Off
	Release the CVT selector button with CVT selector lever in P position		On
DTRL REQ	DTRL OFF		Off
	DTRL ON		On
HOOD SW	Hood closed		On
	Hood open		Off
OIL P SW	NOTE: This item is indicated, but not monitored.		Open/Close
THFT HRN REQ	Not operated		Off
	Panic alarm is activated Horn is activated with VEHICLE SECURITY (THEFT WARNING) SYSTEM		On
HORN CHIRP	Not operated		Off
	Door locking with Intelligent Key (horn chirp mode)		On
HOOD SW 2	Hood closed		Off
	Hood open		On