Front Wiper Control
WARNING: This page is about a different car, the 2020 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
The IPDM E/R detects the front wiper stop position by a front wiper auto stop signal.
When a front wiper auto stop signal is in the conditions listed below, the IPDM E/R stops power supply to the wiper after repeating a front wiper 10 second activation and 20 second stop five times.
|
Push-button ignition switch |
Front wiper switch |
Auto stop signal |
|
ON |
OFF |
Front wiper stop position signal cannot be input 10 seconds. |
|
ON |
The signal does not change for 10 seconds. |
NOTE:
This operation status can be confirmed on the IPDM E/R "Data Monitor" that displays "BLOCK" for the item "WIP PROT" while the wiper is stopped.