Can Communication Control

WARNING: This page is about a different car, the 2020 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

When CAN communication with the ECM and BCM is impossible, the IPDM E/R performs fail-safe control. After CAN communication recovers normally, the IPDM E/R also returns to normal control.

If No CAN Communication Is Available With BCM

Control part	Fail-safe in operation
Headlamp	Turns ON the headlamp low relay when the push-button ignition switch is turned ON Turns OFF the headlamp low relay when the push-button ignition switch is turned OFF Headlamp high relay OFF
Parking lamps Side marker lamps License plate lamps Tail lamps	Turns ON the tail lamp relay when the push-button ignition switch is turned ON Turns OFF the tail lamp relay when the push-button ignition switch is turned OFF
Front wiper	The status just before activation of fail-safe control is maintained until the push-button ignition switch is turned OFF while the front wiper is operating at LO or HI speed. The wiper is operated at LO speed until the push-button ignition switch is turned OFF if the fail-safe control is activated while the front wiper is set in the INT mode and the front wiper motor is operating.
Horn	Horn OFF
Ignition relay	The status just before activation of fail-safe is maintained.