Self Diagnostic Results

WARNING: This page is about a different car, the 2020 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

Refer to DTC Index .

DTC at 1st trip and method to read DTC

DTC (P0705, P0711, P0720, etc.) is specified by SAE J2012/ISO 15031-6.
DTC and DTC at 1st trip are displayed on "Self Diagnostic results" of CONSULT.
When DTC is currently detected, "CRNT" is displayed. If "PAST" is displayed, it shows a malfunction occurred in the past. The trip number of drive without malfunction of concerned DTC can be confirmed with "IGN counter" inside "FFD".
When the DTC at the 1st trip is detected, "1t" is displayed.

DTC deletion method

NOTE: If the ignition switch is left ON after repair, turn OFF the ignition switch and wait for 10 seconds or more. Then, turn the ignition ON again. (Engine stop)

Touch "TRANSMISSION" of CONSULT.
Touch "Self Diagnostic Result".
Touch "Erase". (DTC memorized in TCM is erased.)

IGN counter

The ignition counter is displayed in "FFD" and the number of times of satisfied "Driving condition A" is displayed after normal recovery of DTC.

Refer to Counter System .

If malfunction (DTC) is currently detected, "0" is displayed.
After normal recovery, every time "Driving condition A" is satisfied, the display value increases from 1 -> 2 -> 3...38 -> 39.
When MIL turns OFF due to the malfunction and the counter reaches 40, the DTC is erased.
NOTE: The counter display of "40" cannot be checked.