Work Procedure

WARNING: This page is about a different car, the 2020 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

If Clutch Point Learning is also required, always perform Clutch Point Learning before Select Learning.
Perform Select Learning with CVT fluid temperature below 50 deg.C (122 deg.F) and again with fluid temperature above 50 deg.C (122 deg.F).

PERFORM SELECT LEARNING (DRIVE/REVERSE LEARNING)
1. Set the parking brake.
2. Start the engine and wait 5 seconds.
3. Shift the selector lever to the N position and hold more than 2 seconds, then to D position and wait for transmission engagement.
4. Repeat step 3 ten (10) times.
5. Shift the selector lever to the N position and hold more than 2 seconds, then to R position and wait for transmission engagement.
6. Repeat step 5 ten (10) times.
7. Shift the selector lever to the P position and turn the ignition OFF.
WORK END