Work Procedure

WARNING: This page is about a different car, the 2020 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

PERFORM CALIBRATION OF DECEL G SENSOR (ABS)
Perform calibration of decel G sensor. Refer to Work Procedure (TYPE 1), Work Procedure (TYPE2).

GO TO 2.
PREPARATION BEFORE CALIBRATION PROCEDURE
1. Park the vehicle on a level surface.
2. Adjust air pressure of all tires to the specified pressure. Refer to Tire Air Pressure .
GO TO 3.
PERFORM CALIBRATION OF DECEL G SENSOR (TCM)
With CONSULT
1. Turn ignition switch ON.
  CAUTION: Never start engine.
2. Select "Work Support" in "TRANSMISSION".
3. Select "G SENSOR CALIBRATION".
4. Touch "Start".
  CAUTION: Do not rock or jounce the vehicle during "G sensor calibration".
Is "COMPLETED" displayed?

YES

WORK END

NO

Perform steps 3 again.