Work Procedure

WARNING: This page is about a different car, the 2020 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

WRITING VEHICLE SPECIFICATION
Perform writing vehicle specification.

When writing saved data

GO TO 2.

When writing manually

GO TO 3.
PERFORM WRITING SAVED DATA
With CONSULT
1. Turn ignition switch ON.
2. Select "HVAC" of "Re/programming, Configuration" with CONSULT.
3. Select "After Replace ECU" of "VEHICLE CONFIGURATION", and write the vehicle specification into the A/C auto amp.
WORK END
PERFORM WRITING MANUALLY
With CONSULT
1. Turn ignition switch ON.
2. Select "HVAC" of "Re/programming, Configuration" with CONSULT.
3. Select "Manual selection", and write the vehicle specification to A/C auto amp. Refer to Configuration List .
  CAUTION:
  - Thoroughly read and understand the vehicle specification. ECU control may not operate properly if the setting is not correct.
  - Make sure to select "OK" even if the indicated configuration of brand new A/C auto amp. is the same as the desirable configuration. If not, configuration which is set automatically by selecting vehicle model cannot be memorized.
WORK END