Work Procedure

WARNING: This page is about a different car, the 2020 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

SAVING VEHICLE SPECIFICATION
With CONSULT
1. Turn ignition switch ON.
2. Select "HVAC" of "Re/programming, Configuration" with CONSULT.
3. Select "Before ECU Replacement" of "VEHICLE CONFIGURATION", and save or print the current vehicle specification. Refer to Description .
  NOTE: If "Before ECU Replacement" of "VEHICLE CONFIGURATION" cannot be used, use the "Manual selection" after replacing A/C auto amp. to write vehicle specification.
GO TO 2.
REPLACE A/C AUTO AMP.
1. Turn ignition switch OFF.
2. Replace A/C auto amp. Refer to Removal and Installation .
GO TO 3.
WRITING VEHICLE SPECIFICATION
With CONSULT
1. Turn ignition switch ON.
2. Select "HVAC" of "Re/programming, Configuration" with CONSULT.
3. Select "After ECU Replacement" of "VEHICLE CONFIGURATION", and write the vehicle specification into the A/C auto amp. Refer to Description .
GO TO 4.
OPERATION CHECK
Confirm that each function controlled by A/C auto amp. operates normally.

WORK END