LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 607 (Roof) >> Removal And Installation >> Moonroof Unit Assembly >> Removal and Installation >> Installation

Removal and Installation: Installation

WARNING: This page is about a different car, the 2020 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
  1. Loosely tighten the rear moonroof side bracket bolts to the moonroof unit assembly side rails.
  2. Install moonroof unit assembly into the passenger compartment, loosely install rear moonroof side bracket bolts to roof panel while supporting front.
  3. Align the moonroof unit assembly front end rail and side rails with the locator pins, then loosely install the bolts.
  4. Install remaining moonroof side brackets and loosely tighten bolts.
  5. Tighten the moonroof unit assembly front end and side rail bolts diagonally.
  6. Tighten the front moonroof side bracket bolts at the vehicle side first, then at the side rail end.
  7. Tighten the rear moonroof side bracket bolts at the vehicle side first, then at the side rail end.
  8. Connect the harness connector to the moonroof motor assembly.
  9. Connect drain hoses.
  10. Install the headlining. Refer to Removal and Installation .
scientia non olet · About LEMON Manuals