Data Monitor
|
Monitor Item |
Unit |
Description |
|
SPINDLE SENSOR LH |
[Pulse] |
Displays the condition of the LH encoder |
|
SPINDLE LH SPEED |
[mm/s] |
Displays the LH spindle operation speed |
|
SPINDLE MOTOR LH DUTY |
[%] |
Displays the condition of the spindle motor LH duty |
|
VHCL SPEED MTR |
[km/h] |
Displays the vehicle speed signal received from combination meter by numerical value |
|
VHCL SPEED ABS |
[km/h] |
Displays the vehicle speed signal received from ABS actuator and electrical unit by numerical value |
|
AUTO BD SW |
[ON/OFF] |
Indicates condition of automatic back door switch |
|
BK DOOR CL SW |
[ON/OFF] |
Indicates condition of automatic back door close switch |
|
PKB SW |
[ON/OFF] |
Indicates condition of park brake switch |
|
BACK DOOR LOCK STATUS |
[ON/OFF] |
Indicates condition of back door lock status |
|
OPEN SW |
[ON/OFF] |
Indicates condition of open switch |
|
CLOSE SW |
[ON/OFF] |
Indicates condition of close switch |
|
HALF LATCH SW |
[ON/OFF] |
Indicates condition of half latch switch |
|
TOUCH SEN RH |
[ON/OFF/OPEN] |
Indicates condition of touch sensor RH |
|
TOUCH SEN LH |
[ON/OFF/OPEN] |
Indicates condition of touch sensor LH |
|
P RANGE IND |
[ON/OFF] |
Indicates condition of P range signal from combination meter |
|
RKE REQ |
[OFF/MOVE/REV] |
Indicates condition of remote keyless entry signal from BCM |
|
IGN SW |
[ON/OFF] |
Indicates condition of IGN power supply |
|
SPINDLE LH ENCODER A |
[LO/HI] |
Indicates condition of encoder signal from encoder A |
|
SPINDLE LH ENCODER B |
[LO/HI] |
Indicates condition of encoder signal from encoder B |
|
UNLOCK SEN BD |
[LOCK/UNLK] |
Indicates condition of back door unlock sensor |
|
DESTINATION |
[JPN/NAM] |
Indicates specification of destination of the automatic back door system |
|
AUTO BCK DR POS INITIAL |
[YET/DONE] |
Indicates condition of calibration of automatic back door position information |
|
AUTO BCK DR POS LEARN |
[YET/DONE] |
Indicates condition of additional service when removing battery negative cable |
|
SPINDLE SENSOR RH |
[Pulse] |
Displays the condition of the RH encoder |
|
SPINDLE RH SPEED |
[mm/s] |
Displays the RH spindle operation speed |
|
SPINDLE MOTOR RH DUTY |
[%] |
Displays the condition of the spindle motor RH duty |
|
SPINDLE RH ENCODER A |
[LO/HI] |
Indicates condition of encoder signal from encoder A |
|
SPINDLE RH ENCODER B |
[LO/HI] |
Indicates condition of encoder signal from encoder B |
|
TRANSMISSION TYPE |
[AT/CVT] |
Indicates type of transmission the vehicle is equipped with |
|
CLOSURE OPERATION |
Indicates [ON/OFF] condition of back door auto closure function |
|
|
HANDS FREE SENSOR PWR |
Indicates [ON/OFF] condition of power supply condition for automatic back door control unit |
|
|
AUTO OPEN (BCM) |
Indicates [ON/OFF] condition of key ID verification completed signal, when back door is closed |
|
|
AUTO CLOSE (BCM) |
Indicates [ON/OFF] condition of key ID verification completed signal, when back door is open |
|