Front Door: Adjustment
WARNING: This page is about a different car, the 2020 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
|
1. |
Front fender |
2. |
Front door |
3. |
Rear door |
|
4. |
Body side outer |
5. |
Front door hinge |
6. |
Rear door upper hinge |
|
7. |
Rear door lower hinge |
8. |
Door striker bolts |
9. |
Door striker |
Check the clearance and surface height between front door and each part by visual inspection and tactile feel.
If the clearance and the surface height are out of specification, adjust them according to the adjustment procedure.
Unit: mm (in)
|
Portion |
Section |
Measurement |
Gap measurement |
|
Front fender - Front door |
A - A |
Clearance |
3.8 +/- 1.0 (0.15 +/- 0.04) |
|
Surface height |
+/- 1.0 (+/- 0.04) |
||
|
Front door - Rear door |
B - B |
Clearance |
4.1 +/- 1.0 (0.16 +/- 0.04) |
|
Surface height |
+/- 1.0 (+/- 0.04) |
||
|
Rear door - Body side outer |
C - C |
Clearance |
3.7 +/- 1.0 (0.15 +/- 0.04) |
|
Surface height |
+/- 1.0 (+/- 0.04) |
- Remove front fender. Refer to Removal and Installation .
- Loosen front door hinge nuts on door side.
- Adjust the surface height of front door according to the specifications provided.
- Temporarily tighten front door hinge nuts on door side.
- Loosen front door hinge bolts on body side.
- Raise front door at rear end to adjust clearance of the front door according to the specifications provided.
- After adjustment tighten bolts and nuts to the specified torque.CAUTION:
- Check door hinge rotating point for poor lubrication. If necessary, apply a suitable multi-purpose grease.
- After adjusting, apply touch-up paint (body color) to the head of front door hinge bolts and nuts.
- Install front fender. Refer to Removal and Installation .