Diagnosis Procedure
WARNING: This page is about a different car, the 2020 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK CONNECTOR
- Turn the ignition switch OFF.
- Disconnect the battery cable from the negative terminal.
- Check the following terminals and connectors for damage, bend and loose connection (connector side and harness side).
- Harness connector B69
- Harness connector M40
Is the inspection result normal?
YES
GO TO 2.
NO
Repair the terminal and connector.
- CHECK HARNESS CONTINUITY (OPEN CIRCUIT)
- Disconnect the following harness connectors.
- Harness connectors B400 and B77
- Harness connectors B69 and M40
- Check the continuity between the harness connectors.
Harness connector
Harness connector
Continuity
Connector No.
Terminal No.
Connector No.
Terminal No.
B77
12
B69
81A
Existed
13
80A
Existed
Is the inspection result normal?
YES
GO TO 3.
NO
Repair the main line between the harness connectors B77 and B69.
- Disconnect the following harness connectors.
- CHECK HARNESS CONTINUITY (OPEN CIRCUIT)
- Disconnect the connector of around view monitor control unit.
- Check the continuity between the harness connector and the around view monitor control unit harness connector.
Harness connector
Around view monitor control unit harness connector
Continuity
Connector No.
Terminal No.
Connector No.
Terminal No.
M40
81A
M96
27
Existed
80A
28
Existed
Is the inspection result normal?
YES
Check CAN system type decision again.
YES
Error was detected in the main line between the side radar LH and the around view monitor control unit.
NO
Repair the main line between the harness connector M40 and the around view monitor control unit.