Removal and Installation: Removal

WARNING: This page is about a different car, the 2020 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect negative and positive battery terminals, then wait at least three minutes. Refer to Removal and Installation .
Remove the side lids (LH/RH).
Remove the driver air bag module bolts (LH/RH).
CAUTION: Do not reuse the driver air bag module bolts.
Lift the driver air bag module from the steering wheel.
Disconnect the harness connectors from the driver air bag module and horn.

Courtesy of NISSAN NORTH AMERICA, INC.
CAUTION:
- For removing/installing the driver air bag module harness connector, insert a thin screwdriver wrapped in tape into the notch, then lift the lock and remove the harness connector as shown, above.
- Install the harness connector with the lock raised, and push the lock into the connector as shown, above.
- After installing the connector, check that the lock is pushed in securely.

Remove the driver air bag module.

Courtesy of NISSAN NORTH AMERICA, INC.

CAUTION:

Always place the driver air bag module with pad side facing upward.
: Upward

Replace the driver air bag module if it has been dropped or sustained an impact.

Courtesy of NISSAN NORTH AMERICA, INC.

Do not strike the driver air bag module.
Do not insert any foreign objects (screwdriver, etc.) into the driver air bag module.
Do not disassemble the driver air bag module.
Do not expose the driver air bag module to temperatures exceeding 90 deg. C (194 deg. F).
Do not allow oil, grease, detergent or water to come in contact with the driver air bag module.