Removal and Installation: Installation

WARNING: This page is about a different car, the 2020 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

Installation is in the reverse order of removal.

Align spiral cable correctly before installing steering wheel. Make sure that the spiral cable is in the neutral position. Refer to Removal and Installation .
Adjust the neutral position of the steering angle sensor. Refer to Description .
Tighten steering wheel center nut to specification. Refer to Exploded View .

CAUTION:

The spiral cable may snap due to steering operation if the cable is not installed in the correct position.
With the steering linkage disconnected, the cable may snap by turning the steering wheel beyond the limited number of turns.