Around View Monitor System (DTC/Circuit Diagnosis)

WARNING: This page is about a different car, the 2020 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

CHECK COMMUNICATION SIGNAL CIRCUIT CONTINUITY

Turn ignition switch OFF.
Disconnect around view monitor control unit connector M97 and door mirror LH connector D20.

Check continuity between around view monitor control unit connector M97 and door mirror LH connector D20.

Around view monitor control unit		Door mirror LH		Continuity
Connector	Terminal	Connector	Terminal	Continuity
M97	55	D20	16	Yes

Check continuity between around view monitor control unit connector M97 and ground.

Around view monitor control unit		Ground	Continuity
Connector	Terminal
M97	55	--	No

Is inspection result normal?

YES

GO TO 2.

Repair or replace harness or connectors.

CHECK COMMUNICATION SIGNAL

Connect around view monitor control unit connector M97 and door mirror LH connector D20.
Turn ignition switch ON.

Check signal between around view monitor control unit connector M97 and ground.

Around view monitor control unit		Ground	Condition	Reference value
(+)		(-)
Connector	Terminal
M97	55	--	CAMERA switch is ON or shift position is R.	Courtesy of NISSAN NORTH AMERICA, INC.

Is inspection result normal?

YES

Replace around view monitor control unit. Refer to Removal and Installation .

Replace LH side camera. Refer to Removal and Installation .