Around View Monitor System (DTC/Circuit Diagnosis)
WARNING: This page is about a different car, the 2020 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK REVERSE RANGE SIGNAL
- Turn ignition switch ON.
- Check the voltage between around view monitor control unit harness connector M96 and ground as per the following condition.
Terminals
Condition
Voltage
(Approx.)
(+)
(-)
Around View Monitor control unit
Connector
Terminal
M96
25
Ground
Shift position is "R".
Battery voltage
Shift position other than "R".
0 V
Is the inspection result normal?
YES
Replace around view monitor control unit. Refer to Removal and Installation .
NO
GO TO 2.
- CHECK REVERSE SIGNAL CIRCUIT
- Turn ignition switch OFF.
- Disconnect around view monitor control unit harness connector M96 and BCM harness connector M20.
- Check the continuity between around view monitor control unit harness connector M96 and BCM harness connector M20.
Around view monitor control unit
BCM
Continuity
Connector
Terminal
Connector
Terminal
M96
25
M20
89
Yes
- Check continuity between around view monitor control unit connector M96 and ground.
Around view monitor control unit
Ground
Continuity
Connector
Terminals
M96
25
No
Is the inspection result normal?
YES
Replace BCM. Refer to Removal and Installation .
NO
Repair or replace harness or connectors.