LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 596 (Around View Monitor System (DTC/Circuit Diagnosis)) >> DTC/Circuit Diagnosis >> DTC U1232: Steering Angle Sensor >> Diagnosis Procedure

Diagnosis Procedure

WARNING: This page is about a different car, the 2020 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
  1. ADJUST THE PREDICTIVE COURSE LINE CENTER POSITION OF THE STEERING ANGLE SENSOR 

    Adjust the steering angle sensor neutral position on ABS actuator and electrical unit (control unit) side. Refer to Work Procedure (VDC/TCS/ABS TYPE1) or Work Procedure (VDC/TCS/ABS TYPE2).

    NOTE: When DTC U1232 is detected, adjust the predictive course line center position of the steering angle sensor.

    GO TO 2.

  2. PERFORM DTC CONFIRMATION PROCEDURE 

    SYMBOL CONSULT

    1. Turn ignition switch ON.
    2. Erase DTC.
    3. Select "Self diagnostic result" mode of "AVM".
    4. Check DTC.

    Is DTC U1232 detected?

    YES

    Replace steering angle sensor. Refer to Removal and Installation (VDC/TCS/ABS TYPE1) or Removal and Installation (VDC/TCS/ABS TYPE2).

    NO

    Inspection End.

scientia non olet · About LEMON Manuals