Around View Monitor System (DTC/Circuit Diagnosis)
WARNING: This page is about a different car, the 2020 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK SONAR BUZZER SIGNAL CIRCUIT OPEN OR SHORT TO GROUND
- Turn ignition switch OFF.
- Disconnect sonar control unit and sonar buzzer connectors.
- Check continuity between sonar control unit connector M70 and sonar buzzer connector B35.
Sonar control unit
Sonar buzzer
Continuity
Connector
Terminal
Connector
Terminal
M70
19
B35
2
Yes
20
3
- Check continuity between sonar control unit connector M70 and ground.
Sonar control unit
Ground
Continuity
Connector
Terminal
M70
19
--
No
20
Is the inspection result normal?
YES
GO TO 2.
NO
Repair or replace harness or connectors.
- CHECK SONAR BUZZER SIGNAL CIRCUIT SHORT TO BATTERY
- Turn ignition switch ON.
- Check voltage between sonar control unit connector M70 and ground.
Sonar control unit
Ground
Voltage
(Approx.)
Connector
Terminal
M70
19
--
0 V
20
Is the inspection result normal?
YES
Replace sonar buzzer. Refer to Removal and Installation .
NO
Repair or replace harness or connectors.