Meter, Warning Lamp & Indicator (DTC/Circuit Diagnosis)
WARNING: This page is about a different car, the 2020 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK WASHER FLUID LEVEL SWITCH SIGNAL CIRCUIT
- Turn ignition switch OFF.
- Disconnect combination meter harness connector M23 and washer fluid level switch harness connector E208.
- Check continuity between combination meter harness connector M23 and washer fluid level switch harness connector E208.
Combination meter
Washer fluid level switch
Continuity
Connector
Terminal
Connector
Terminal
M23
49
E208
1
Yes
- Check continuity between combination meter harness connector and ground.
Combination meter
Ground
Continuity
Connector
Terminal
M23
49
No
Is the inspection result normal?
YES
GO TO 2.
NO
Repair or replace harness or connectors.
- CHECK WASHER FLUID LEVEL SWITCH GROUND CIRCUIT
Check continuity between washer fluid level switch connector and ground.
Washer fluid level switch
Ground
Continuity
Connector
Terminal
E208
2
Yes
Is the inspection result normal?
YES
Inspection End.
NO
Repair or replace harness or connectors.