Meter, Warning Lamp & Indicator (DTC/Circuit Diagnosis)

WARNING: This page is about a different car, the 2020 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

CHECK STEERING SWITCH CIRCUIT

Turn ignition switch OFF.
Disconnect combination meter harness connector M24 and spiral cable harness connector M30.

Check continuity between combination meter harness connector M24 and spiral cable harness connector M30.

Combination meter		Spiral cable		Continuity
Connector	Terminal	Connector	Terminal
M24	3	M30	24	Yes
	4		31
	24		33

Check continuity between combination meter harness connector M24 and ground.

Combination meter		Ground	Continuity
Connector	Terminal
M24	3		No
	4
	24

Is the inspection results normal?

YES

Inspection End.

Repair or replace harness or connectors.