Meter, Warning Lamp & Indicator (DTC/Circuit Diagnosis)

1. Turn ignition switch OFF.
2. Check combination meter and fuel level sensor unit terminals (meter-side and harness-side) for poor connection.

Is the inspection result normal?

YES

GO TO 2.

NO

Repair or replace terminals or connectors.

1. Disconnect combination meter harness connector M24 and fuel level sensor unit harness connector B72.
2. Check continuity between combination meter harness connector M24 and fuel level sensor unit and fuel pump harness connector B72.

   Fuel level sensor unit and fuel pump		Combination meter		Continuity
   Connector	Terminal	Connector	Terminal
   B72	5	M24	27	Yes

3. Check continuity between fuel level sensor unit and fuel pump harness connector and ground.

   Connector	Terminal	Ground	Continuity
   B72	5		No

Is the inspection result normal?

YES

GO TO 3.

NO

Repair or replace harness or connectors.

1. Check continuity between combination meter harness connector M24 and fuel level sensor unit and fuel pump harness connector B72.

   Connector	Terminal	Connector	Terminal	Continuity
   B72	2	M24	26	Yes

2. Check continuity between fuel level sensor unit and fuel pump harness connector and ground.

   Connector	Terminal	Ground	Continuity
   B72	2		No

Is the inspection result normal?

YES

GO TO 4.

NO

Repair or replace harness or connectors.

Check fuel level sensor unit installation, and check whether the float arm interferes or binds with any of the internal components in the fuel tank.

Is the inspection result normal?

YES

Inspection End.

NO

Install the fuel level sensor unit properly. Refer to Removal and Installation .