Diagnosis Procedure
WARNING: This page is about a different car, the 2018 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK INTERIOR ROOM LAMP POWER SUPPLY OUTPUT
CONSULT
- Turn ignition switch OFF.
- Disconnect the following connectors:
- Personal lamps rear
- Front room/map lamp assembly
- Trunk room lamp
- Foot lamps
- Front step lamps
- Vanity mirror lamps
- Turn ignition switch ON.
- Select "BATTERY SAVER" in "Active Test" mode of "BCM".
- While operating the test item, check voltage between BCM harness connector and ground.
BCM
(-)
Test item
Voltage
(Approx.)
(+)
Connector
Terminal
M17
137
Ground
BATTERY SAVER
On
0V
Off
Battery voltage
Is the inspection result normal?
YES
GO TO 2 .
NO
Replace BCM. Refer to Removal and Installation .
- CHECK INTERIOR ROOM LAMP POWER SUPPLY OPEN CIRCUIT
- Turn ignition switch OFF.
- Disconnect the BCM connector.
- Check continuity between BCM harness connector and each interior room lamp harness connector.
BCM
Each interior room lamp
Continuity
Connector
Terminal
Connector
Terminal
M17
137
Front room/map lamp assembly
R8
1
Yes
Trunk room lamp
B36
Foot lamp LH
M99
Foot lamp RH
M100
Front step lamp LH
D11
Front step lamp RH
D109
Vanity mirror lamp LH
R3
2
Vanity mirror lamp RH
R9
Personal lamp rear LH
R12
4
Personal lamp rear RH
R11
Is the inspection result normal?
YES
Check intermittent incident. Refer to Intermittent Incident .
NO
Repair or replace harnesses.