LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 586 (Front Suspension) >> Removal And Installation >> Transverse Link >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2020 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove front wheels and tires using power tool. Refer to Road Wheel .
  2. Remove brake caliper torque member bolts, leaving brake hose attached, reposition the caliper aside with wire. Refer to Removal and Installation .
    CAUTION: Do not depress brake pedal while brake caliper is removed.
  3. Put alignment marks on disc rotor and wheel hub and bearing assembly, then remove disc rotor.
    CAUTION:
    • Put alignment marks on the wheel hub and bearing assembly and the disc rotor before removing the disc rotor.
    • Do not drop the disc rotor.
  4. Remove speed sensor.
  5. Disengage the drive shaft from wheel hub and bearing assembly. Refer to Exploded View (LH) and Exploded View (RH) .
  6. Separate the outer socket from the knuckle. Refer to Exploded View .
  7. Remove the strut from the knuckle using power tool. Refer to Exploded View .
  8. Remove transverse link from steering knuckle.
  9. Remove the steering knuckle and hub.
  10. Remove transverse link nuts and bolts.
  11. Remove transverse link from suspension member.
scientia non olet · About LEMON Manuals