Removal and Installation: Installation
WARNING: This page is about a different car, the 2020 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
- Install the brake caliper to torque member and install the sliding pin bolts. Tighten to specification.
- Install the brake caliper and torque member to the vehicle as an assembly. Install the torque member bolts.
- Assemble the union bolt (A) and the copper sealing washers (1) to the brake hose and install it as an assembly to the brake caliper. Align the brake hose L-pin by aligning it with the brake caliper hole, and tighten the union bolt (1) to the specified torque.CAUTION: Do not reuse copper sealing washers.
- Refill with new brake fluid and perform the air bleeding. Refer to Bleeding Brake System .CAUTION:
- Do not reuse drained brake fluid.
- Do not spill or splash brake fluid on the disc brake rotor.
- Check the rear disc brakes for drag.
- Install the rear wheels and tires. Refer to Adjustment .