Removal and Installation: Installation
WARNING: This page is about a different car, the 2020 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
- Apply Molykote® 7439 to inner and outer surfaces of the brake pad retainers.
- Install the new pad retainers and anti-rattle clips to the torque member.CAUTION:
- Do not reuse the pad retainers and anti-rattle clips.
- Do not deform the pad retainers.
- Verify that the pad retainers are secured properly to the torque member.
- Apply Molykote® AS-880N grease to the mating faces between the inner shim, inner shim cover, outer shim and outer shim cover and install them to the brake pad. Refer to Exploded View .CAUTION: When installing new brake pads, replace the shims and shim covers.
- Install the brake pads to the torque member.
- Using a suitable tool, press the pistons into the brake caliper.CAUTION: Do not damage the piston boot.
- Install the brake caliper to the torque member.
- Install the slide pin bolts and tighten to specification. Refer to Exploded View .
- Depress the brake pedal several times and verify that drag does not exist.
- Install the front wheels and tires. Refer to Adjustment .
- Check brake fluid level and refill as necessary. Refer to Inspection .