Removal and Installation: Installation

WARNING: This page is about a different car, the 2020 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Do not allow foreign matter (e.g. dust) and oils other than brake fluid to enter the reservoir tank.

Assemble the union bolt (A) and the copper sealing washers (1) to the brake hose and install it as an assembly to the brake caliper. Align the brake hose L-pin by aligning it with the brake caliper hole, and tighten the union bolt (1) to the specified torque.

Courtesy of NISSAN NORTH AMERICA, INC.

CAUTION: Do not reuse copper sealing washers.
Install the brake pipe to the brake hose, temporarily tighten the flare nut by hand until it does not rotate further, and attach the brake hose to the bracket with the lock plate.
CAUTION: Check that the brake hoses and pipes are not bent or twisted.
Tighten the flare nut to the specified torque with a crowfoot and a torque wrench.
CAUTION: Do not scratch the flare nut and the brake pipe.
Refill with new brake fluid and perform the air bleeding. Refer to Bleeding Brake System .
CAUTION: Do not reuse drained brake fluid.
Install the wheels and tires. Refer to Adjustment .
Perform inspection after installation. Refer to Inspection .